E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > Search Forums

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: Andy Macdonald
Forum: RDM General Implementation Discussion February 6th, 2009
Replies: 6
Views: 6,781
Posted By Andy Macdonald
Eric, I completely agree that you can make...

Eric,

I completely agree that you can make assumptions, and that if you're just trying to select the correct fixture personality you won't need to know the software version or RDM protocol...
Forum: RDM General Implementation Discussion February 5th, 2009
Replies: 6
Views: 6,781
Posted By Andy Macdonald
Thanks for the reply. I agree that it's not laid...

Thanks for the reply. I agree that it's not laid down in the spec (at least I couldn't find it anywhere), but I'm trying to find a solution to the following:

After discovering all the fixtures in...
Forum: RDM General Implementation Discussion February 5th, 2009
Replies: 6
Views: 6,781
Posted By Andy Macdonald
Uniquely defining the RDM response of devices

If a controller discovers two devices which respond with the same
- Manufacturer ID
- RDM protocol version
- Device Model ID
- Software Version ID
- DMX512 Personality
is it correct to say that...
Forum: RDM Physical Layer/Hardware Discussion October 20th, 2006
Replies: 1
Views: 7,653
Posted By Andy Macdonald
Line biasing

Scott,

I'm sure you're busy at LDI, but when you're back in the office and have a moment, could you explain a little of the background to line biasing please. What is it used for/why does it...
Forum: RDM Interpretation Questions October 16th, 2006
Replies: 4
Views: 7,031
Posted By Andy Macdonald
Scott, Thanks for your reply, and apologies...

Scott,

Thanks for your reply, and apologies for the delay in following it up.

Para 9.2.3 of the spec says "all sub-devices shall report an identical list for SUPPORTED_PARAMETERS". I presume...
Forum: RDM Interpretation Questions October 5th, 2006
Replies: 4
Views: 7,031
Posted By Andy Macdonald
Device Models

This may seem a little obvious, but I wanted to check what people understand by the term "Model" in an RDM context? It's not mentioned in Appendix D (Definitions). I ask because of the requirement in...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -6. The time now is 06:08 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.