E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > Search Forums

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: ericthegeek
Forum: RDM Interpretation Questions December 17th, 2018
Replies: 16
Views: 9,081
Posted By ericthegeek
Fully agree. You probably noticed that I didn't...

Fully agree. You probably noticed that I didn't include every NACK Reason code in my category list because, as you point out, there are varying degrees of finality.


Please don't think I'm...
Forum: RDM Interpretation Questions December 16th, 2018
Replies: 16
Views: 9,081
Posted By ericthegeek
Peter, There can be endless battles...

Peter,



There can be endless battles about which NACK Reason Code to use in a myriad of situations. There's no "right" answer to many of those cases. This is especially true when looking at...
Forum: RDM Interpretation Questions December 10th, 2018
Replies: 16
Views: 9,081
Posted By ericthegeek
I'd suggest using NR_UNKNOWN_PID for GET also for...

I'd suggest using NR_UNKNOWN_PID for GET also for the reason you mention (symmetry), but either behavior is OK.


You will need to use 0xFFFF in the Device Info Response since that field is always...
Forum: RDM Interpretation Questions December 3rd, 2018
Replies: 16
Views: 9,081
Posted By ericthegeek
IMO using NR_ACTION_NOT_SUPPORTED is a very bad...

IMO using NR_ACTION_NOT_SUPPORTED is a very bad idea.

That NACK Reason code was not defined until E1.37-2 in 2014. Many controllers (especially older controllers and those that have not...
Forum: RDM Interpretation Questions December 3rd, 2018
Replies: 16
Views: 9,081
Posted By ericthegeek
NR_UNKNOWN_PID

NR_UNKNOWN_PID
Forum: RDM Interpretation Questions December 3rd, 2018
Replies: 16
Views: 9,081
Posted By ericthegeek
Most controllers won't display the UI that allows...

Most controllers won't display the UI that allows you to set the DMX address when the responder has a zero slot footprint. This means you won't even be able to send the SET request most of the time....
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -6. The time now is 02:26 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.