E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM Timing Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=7)
-   -   Driver Enable Time (http://www.rdmprotocol.org/forums/showthread.php?t=1059)

luiscolo February 7th, 2010 07:03 PM

Driver Enable Time
 
Hello!
I have a quiestion about Driver Enable Time

Section 3.2.3 specifies the response driver enable time for Responder discovery

but I can't find the response driver enable time for non discovery responses

Does anybody know the answer?
I thank you in advance,
Luis

sblair February 7th, 2010 08:34 PM

Luis,

Welcome to the forums. There are tighter requirements for the timing in discovery than normal messages due to the fact that the controller is looking for any traffic on the line to indicate the presence of a device in discovery. The reason for Section 3.2.3 is to prevent a branch being missed because one device is holding the line high while another device is trying to respond. By limiting a device from holding a the line in a marking state we are guaranteed that a controller can see the line state change when multiple devices are responding.

Simply put, this additional requirement doesn't exist for non-discovery responses as there should only be one responder active on the line at that point and we don't have to worry about detecting a collision.

For non-discovery messages you'll just need to comply with the timing elements from E1.11 (DMX512) and the other timing requirements in Section 3.2 of E1.20.


All times are GMT -6. The time now is 12:32 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.