Cable shield connection questions
Hello,
It is pretty cear from the DMX spec that a transmitter must have <20Ohm between shield and chassis and a receiver (non isolated) must have 100Ohm. This is cool BUT what if a device can be a RDM controller AND a RDM responder, depending on the mode? Is it expected to switch in and out a 100Ohm resistor? If it needs to be switched, is there a way to do it without a relay? Kind regards Bernt |
All times are GMT -6. The time now is 09:11 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.