E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM General Implementation Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=4)
-   -   capture & playback preset (http://www.rdmprotocol.org/forums/showthread.php?t=1020)

chris August 4th, 2009 12:14 PM

capture & playback preset
 
Hi i'm currently implementing capture & playback preset capability unfortunately i think theres a couple of functions that could do with adding
1 the ability to delete a preset as currently there doesnt seem to be any way of doing this except for man specific pid
2 the ability to set the preset playback range so you can have lot of presets but only playback a small sequence of presets by setting the upper & lower preset numbers
hopefully this will give food for thought
many thanks
chris

ericthegeek August 4th, 2009 05:45 PM

There are some additional PIDs relating to preset playback being discussed as part of E1.37 "Additional Message Sets for ANSI E1.20 (RDM)". I don't have the latest draft in front of me, but I believe it did include a "Delete Preset" PID.

I believe the intention of PRESET_PLAYBACK_ALL is to basically serve as a "Go internal sequence" for the responder. There was some discussion of adding more sophisticated control over sequencing, but it quickly became clear you'd have to reimplement an entire lighting controller to meet everyone's needs.


All times are GMT -6. The time now is 08:42 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.