E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM Interpretation Questions (http://www.rdmprotocol.org/forums/forumdisplay.php?f=5)
-   -   DISC_UNIQUE_BRANCH dest UID (section 7.3) (http://www.rdmprotocol.org/forums/showthread.php?t=695)

berntd October 8th, 2008 08:46 PM

DISC_UNIQUE_BRANCH dest UID (section 7.3)
 
Hello

Must the DISC_UNIQUE_BRANCH command always be sent to destination UID = BROADCAST_ALL_DEVICES_ID (Appendix A p 101)?

I would like to send it to ALL_DEVICES_ID (0xmmmmFFFFFFFF) instead and in my interpretation, that should be fine and valid or am I misinterpreting something?


Kind regards
bernt

sblair October 8th, 2008 11:06 PM

Bernt,

There is no reason why that shouldn't work or be allowed. However I could potentially see a case where someone didn't think of that case in their code and somehow doesn't handle it. All my code is handled in a why that it would work fine in my products.

I think there might be a better way to do it though that will do the exact same thing and likely eliminate any potential issues.

Send the DISC_UNIQUE_BRANCH message to the BROADCAST_ALL_DEVICES_ID but set your upper and lower bounds for the discovery routine to be within that manufactuerer ID.

In other words set the lower bound to: 0xmmmm00000000 and upper bound to: 0xmmmmFFFFFFFF.

That should do the exact same thing and be guaranteed to work.

berntd October 9th, 2008 03:52 PM

Hi Scott

I am just checking because I have a feeling that a product (a proxy) I am interfacing with is getting a bit confused maybe.
I am not sure if thisis causing the trouble or something else but what I am seing on the other side of the proxy is very not what I expect nor will it work that way.


I am actually sending the discovery address boundaries exactly as you mentioned.

Regards
Bernt

sblair October 11th, 2008 06:44 PM

Bernt,

A proxy will typically do it's own independent discovery. There are then messages you can use to just get a packed list of all the UID's it has discovered. This results in a generally much faster discovery in a large system.

The proxy is free to do its own discovery, so trying to limit it in the way you want to probably won't be possible from the upstream side of the proxy.

What is the issue you are trying to solve by limiting discovery to a specific manufacturer ID only?

berntd October 15th, 2008 09:34 PM

Hi Scott,

No issue in particular. It was just done that way at the time and I am now wondering with hindsight if it was correct.

Kind regards
Bernt

sblair October 15th, 2008 10:06 PM

I think limiting it using the upper and lower bounds is probably going to be the most effective across different implementations.


All times are GMT -6. The time now is 10:59 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.