E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM General Implementation Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=4)
-   -   Simple dimmer error reporting (http://www.rdmprotocol.org/forums/showthread.php?t=889)

Milton Davis November 6th, 2008 05:00 PM

Simple dimmer error reporting
I am in the middle of making a simple RDM device which is composed of a conventional lamp integrated with a dimmer. There is a crude current sensing mechanism. It is only intened to determine whether the lamp is good or not. I don't care whether the wattage is 200W or 300W, etc.; just is it there or not.

When reporting the status of the fixture/dimmer, are there any suggestions as to what status message would be most appropriate? The closest entries in the Standard are STS_BREAKER_TRIPPED, STS_WATTS, and STS_DIM_FAILURE. None of these is really a correct description of the error state. Any ideas or experience from others?

Milton Davis

sblair November 6th, 2008 08:28 PM


I think STS_WATTS is probably the closest as you can then report "0 Watts", which would be correct.

A Lamp fail message would probably be most useful. This list is meant to easily be extended just by sending a request in to Karl to add a new public one since it sounds like it would be general purpose.

prwatE120 November 7th, 2008 07:22 AM

Please request a new message STS_LOAD_FAILURE

Peter Willis

Milton Davis November 7th, 2008 11:15 AM

Thanks Scott/Peter. I will write up a request later today. It's really a little surprising that none of us caught this hole before now... "is it plugged in?"...


All times are GMT -6. The time now is 10:21 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.