E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM Interpretation Questions (http://www.rdmprotocol.org/forums/forumdisplay.php?f=5)
-   -   PRESET_PLAYBACK (http://www.rdmprotocol.org/forums/showthread.php?t=1039)

berntd October 18th, 2009 11:03 PM

PRESET_PLAYBACK
 
Hello,

if the device does not support PRESET_PLAYBACK_ALL (table A-7)
should it NACK with DATA_OUT_OF_RANGE or ACK and ignore?

Likewise, if the device dioes not support the level setting of this PID, should it NACK with DATA_OUT_OF _RANGE for value other than 0sFF or ACK and ignore?

Kind regards
Bernt

ericthegeek October 18th, 2009 11:14 PM

> if the device does not support PRESET_PLAYBACK_ALL
> should it NACK with DATA_OUT_OF_RANGE or ACK and
> ignore?

I'd vote for a NACK, then the controller knows it was received and explicitly rejected.

> if the device dioes not support the level setting
> of this PID, should it NACK with DATA_OUT_OF _RANGE
> for value other than 0sFF or ACK and ignore?

For most dimmers, I'd probably ACK the request and ignore the level (treat it like 0xFF). I think either behavior is acceptable though.


All times are GMT -6. The time now is 08:10 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.