E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM General Implementation Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=4)
-   -   Sensor type and Sensor unit for No of Phases question (http://www.rdmprotocol.org/forums/showthread.php?t=1032)

berntd October 1st, 2009 06:25 PM

Sensor type and Sensor unit for No of Phases question
 
Hello again,

Here is another one,
What sensor type and units should I use for the number of active mains phases?

I can't see anything obviously suitable by just looking at Tables A-12/A-13.


Kind reagdrs
Bernt

ericthegeek October 1st, 2009 10:04 PM

Is it a device where you expect the number of phases to change on a regular basis (like a dimmer pack that can be wired for single phase or three phase)?

You could have multiple voltage sensors, and report the voltage for each input phase separately.

Or, SENS_OTHER and a Manufacturer-Specific Unit along with a well-written text string should work for most controllers.


All times are GMT -6. The time now is 11:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.