E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM Interpretation Questions (http://www.rdmprotocol.org/forums/forumdisplay.php?f=5)
-   -   CAPTURE_PRESET pdl? (http://www.rdmprotocol.org/forums/showthread.php?t=1038)

berntd October 18th, 2009 09:55 PM

CAPTURE_PRESET pdl?
 
Hello all,

the pdl for this is mentioned as either 2 or 8 but in the text (10.11.8) it mentiones that unused timing fields shall be set to 0.

Does this imply that the pdl is always 8?

Kidn regards
Bernt

ericthegeek October 18th, 2009 11:19 PM

No, both PDL's are valid.

You might use 0x0000 in one of the timing fields if you have fade times, but no wait time.

berntd October 19th, 2009 04:18 PM

Hello,

How does a controller figure out how mane scenes are available in a device?

This question also applies to some other commands - I suppose.

Kind regards
Bernt

ericthegeek October 19th, 2009 09:45 PM

Unfortunately there's no standard way to determine the number of scenes a responder supports, other than getting a NACK when you try and use a scene that the responder doesn't support.

sblair October 19th, 2009 09:52 PM

Eric is correct. I believe we have some new messages that extend this in the Dimmer PID's document we're currently working on that extend the capabilities of Presets.


All times are GMT -6. The time now is 06:58 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.