E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM Physical Layer/Hardware Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=6)
-   -   Wires in RDM connection (http://www.rdmprotocol.org/forums/showthread.php?t=1264)

Nelly September 13th, 2017 05:50 AM

Wires in RDM connection

First I want to tell I am completely new in this field. I am in the middle of my education and right now I have one term in a company. So please excuse me if my question doesn't make any sense.

I have bought a USB to RS-485 converter and want to communicate with a driver called eldoLED Powerdrive 562/S.

Now I need to find a way to connect the subd9 to a RJ45 cable so I can connect it into into the driver. I have attached a picture that shows my components.

What wires in the RJ45 cable should I connect with the subd9 to make it communicate with the driver? The driver does support RDM.

Hope its well explained and someone can help me solve my problem.

https://imgur.com/a/Xzuml Here is the link for the picture.



sblair September 13th, 2017 11:30 AM


Can you try posting again with the picture? I didn't come through, possibly because it was a new account that hadn't been approved yet, but it is now.


Nelly September 14th, 2017 01:39 AM

Hello Scott,

Guess you are right about that, I had som troubles posting yesterday. I have edited my original post, so you should be able to see the link to the picture now.


All times are GMT -6. The time now is 10:16 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.