E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM General Implementation Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=4)
-   -   Status Messages (http://www.rdmprotocol.org/forums/showthread.php?t=1317)

Thierry Dupont November 20th, 2020 04:04 PM

Status Messages
 
Hello,

We implemented Status_Messages in Sully our latest product.
We tested it successfully with RDM_Integrity but we are quite disappointed as it seems that very few controllers have implemented it.
Our goal was to send back messages to controller to warn operators.

Below the test results we did on several controllers available to us:
ENTTEC RDM controller: OK
GET SET 5.036: not displaying the advisory messages
DMXworkshop: NO
DMXcat: Not yet
MA2: NO
DMXLan 4.41: There is a function for it but it does not work.
LXNetTools: NO
Pathscape 4.0: NO
MADRIX Radar 1.0: NO but it should be. It is implemented but it is not working.


Does anyone knows which controller handle Status_Messages especially among lighting desks?

Thanks
Thierry

FishAI November 26th, 2020 06:22 AM

Hi Thierry,


STATUS_MESSAGE is indeed implemented in MADRIX RADAR.
Please see my response to your request in the MADRIX support forum.


Best regards,
FishAI


All times are GMT -6. The time now is 06:20 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.