E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM Physical Layer/Hardware Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=6)
-   -   DMXter4 error 0002: DISC MUTE? (http://www.rdmprotocol.org/forums/showthread.php?t=1261)

dj41354 July 21st, 2017 01:02 PM

DMXter4 error 0002: DISC MUTE?
 
Hey Eric..
I've been adding some new personalities to our lights and think I've accidentally affected my RDM code. When I try and run Integrity using my DMXter4 with my new firmware, the DMXter says:
0002: DISC MUTE
NOISE/DATA w/o BRK
at which point Integrity hangs..
Can you tell me what the DMXter might be unhappy with that causes this error message?
Thanks..

ericthegeek July 23rd, 2017 03:41 PM

The controller found your responder via DUB. When it tried to mute the responder, it didn't get a valid response. There was activity on the line during the response period (either noise or data), but there wasn't a valid break beforehand, so the response is not valid.


All times are GMT -6. The time now is 03:08 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.