DMX
I am developing code in STM32F407 Controller and i have taken RGBW mode in DMX. now i am looking to add strobe effect to RGBW. iam setting the PWM and making it zero after some delay. at slower delays like 25ms the lights are hangging. i thought that is because of interrupt during delay. so i implemented timer delay concept there also iam facing same issue. Can some one suggest solution for this
|
i want simultaneous option of change in PWM and strobe at different speeds.
In manual it is working fine but in DMX it is hanging in timers i am setting prescale to 84 and ARR to 99. |
We have a lot of experience with the protocols here, but not much experience with any particular microcontroller. I suspect the answer will depend on the behavior of the specific PWM block in your chip.
|
Quote:
|
Quote:
|
All times are GMT -6. The time now is 12:25 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.