E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM Interpretation Questions (http://www.rdmprotocol.org/forums/forumdisplay.php?f=5)
-   -   Discovery Mute/Un mute (http://www.rdmprotocol.org/forums/showthread.php?t=19)

nic123 June 14th, 2006 12:59 AM

Discovery Mute/Un mute
discussion followed on from yaho groups:

>The only Broadcast message that responders reply to is the
>I don't monitor these forums that close, so you'll get faster responses in
>the RDM Protocol Developer forums that we've recently opened at

Page 36 of spec seems to say there are response packets for both of those.


sblair June 14th, 2006 10:28 AM

It says that it must Set or Clear the Mute flag when it receives a Mute or Un-Mute message on a Broadcast address or it's own address.

That does not mean that it responds on the link though when receiving a Broadcast message. You can also send a Broadcast message for everyone to set their DMX Address to 1. All the devices do that action, but since it was a Broadcast message, they know not to respond.

The only message that should get a response when sent to a Broadcast address is the DISC_UNIQ_BRANCH message.

All times are GMT -6. The time now is 08:36 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.