E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums (http://www.rdmprotocol.org/forums/index.php)
-   RDM General Implementation Discussion (http://www.rdmprotocol.org/forums/forumdisplay.php?f=4)
-   -   change parameter setting (http://www.rdmprotocol.org/forums/showthread.php?t=1253)

ilek79 January 12th, 2017 01:04 AM

change parameter setting
 
hello.
i got a lot of help from this forum.
thank you for that.

and i have some problem and need for help from sir.
i use DMX Personality to change DMX set.
i have another parameter setting to change.
that parameter is my product's setting.
how can i change parameter setting with RDM.
Please tell me about that.
thank you.

sblair January 12th, 2017 01:17 AM

Please provide some more detail so I can better understand your question. Are you using an existing product or developing one? Basically speaking, your device has to have RDM implemented and changing a parameter setting is then done using a controller that sends a SET_COMMAND message to change that parameter setting.

The more specific information you can provide the better the answer we can provide here.

ilek79 January 12th, 2017 01:44 AM

Thank you for answer.
my question's detail information is not good, Sorry about that.

i'm now developing one, and RDM function is ready to use.
Discovery, Change DMX Address, Read Temperature Sensor, Change Device Label, Change DMX Personality.... all is possible.

i want device's parameter setting.
device is led light,
and if i want change Light's Kelvin setting or operation mode change.
how can i change that.
please tell me about that.
thank you

sblair January 12th, 2017 07:20 PM

The message to use to change the operating mode or DMX library that is used would be the DMX_PERSONALITY message.

There currently is not a standardized message for doing tunable white (i.e. changing Kelvin temperature) but you could do this by using a Manufacturer-specific message as explained in the standard.

ilek79 January 12th, 2017 09:15 PM

Thank you for Answer
as i understand, change parameter is using DMX_PERSONALITY and
Manufacture-specific massage.
another way is not possible.

thank you for answer.
think about Manufacture-specific massage.
have a good day.


All times are GMT -6. The time now is 07:20 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.