E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM Interpretation Questions

RDM Interpretation Questions Discussion and questions relating to interpreting and understanding the E1.20 RDM Standard.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old February 25th, 2014   #1
LarryDew
Junior Member
 
Join Date: Aug 2013
Posts: 4
Default Support a given PID with a GET but not a SET

For a given PID, if I support the GET must I support the SET. Example IDENTIFY_MODE: GET returns QUITE but I don't not have a LOUD setting so setting it to LOUD does nothing. Should I return a NR_DATA_OUT_OF RANGE or NR_UNSUPPORTED_CC? In general, if I am testing for a supported PID is it required to support both GET and SET command classes?
Thanks
LarryDew is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
ACT_TIMER to Set messages nic123 RDM Interpretation Questions 3 April 18th, 2014 12:01 PM
DMX_BLOCK_ADDRESS (Set) hamish RDM Interpretation Questions 7 June 26th, 2013 02:53 AM
Sub-device response to SET/GET DMX512 start address p_richart RDM Interpretation Questions 2 September 29th, 2006 09:27 AM


All times are GMT -6. The time now is 07:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.