E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old January 18th, 2013   #1
luiscolo
Junior Member
 
Join Date: Feb 2010
Posts: 7
Smile status error queued?/status id definnition

Hi everyone!
I'm working on the "collection of queued and status messages"
I have a couple of questions:

1) Consider the following case:
a responder has it's queue message empty
the temperature sensor is in overtemp condition,

may the responder flag a pending message queued in it's message count?
in the next queued message request it will inform the overtemperature condition with a status message,

Is this a valid mechanism? I know it's not exactly a queued message, but if the controller, for any reason, do not requiere status messages and based on the "non queued messages" info, may pospond their known about the overtemp info,

2) Based on the "power state defines", a responder could fail to re-enable his power supply to return to normal state from standby or shutdon state, how it must inform this? there is no status id definition for power supply failure,

I think i can create a sensor that monitors the power supply (in fact it's an optocoupler that monitor this condition), and report an undervoltage error, but is not the exactly case, do you think that we may add the ppower supply failure to the status id definitions or only (and not straightly) create a virtual sensor that monitors if the supply succeds to turn on and repoort them as 12V (for example) or if it fails report them as 0 volts?

thanks in advance and sorry for my poor english,
Luis Bolster
luiscolo is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Units in Status Messages tomsteer RDM General Implementation Discussion 2 September 26th, 2012 07:44 AM
Sub-Device Status Threshold ericthegeek RDM Interpretation Questions 3 August 15th, 2011 11:29 PM
Status Message Markers hamish RDM General Implementation Discussion 4 December 9th, 2010 11:12 PM
When to use Queued Msg VS Status Msg Mark_C RDM General Implementation Discussion 3 January 12th, 2010 01:08 PM


All times are GMT -6. The time now is 06:09 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.