E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM User Forums > DMX512 Discussion

DMX512 Discussion Discussion and questions relating to DMX512-A and DMX512/1990.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old November 8th, 2018   #1
zano_villa
Junior Member
 
Join Date: Jan 2014
Location: Treviso, Italy
Posts: 13
Default BREAK timing at the receiver

Hello,
This is the my question: can a DMX receiver consider a signal low level lower than 88us as a BREAK?
If the answer in NO, this is a framing error (stop bit error): in this case may the receiver accept previous slots of the frame?
DMX512-A 9.1 says it must only discard improperly framed slot data and all following slots in the packet.
Am I right?


Thank you
zano_villa is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
DMX break timing majid RDM Timing Discussion 2 December 30th, 2017 06:15 AM
Summed Break and MAB time kster RDM Timing Discussion 4 July 6th, 2009 09:01 PM


All times are GMT -6. The time now is 07:02 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.