E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM Timing Discussion

RDM Timing Discussion Discussion and questions relating to the timing requirements of RDM.

Reply
 
Thread Tools Search this Thread Display Modes
Old March 29th, 2007   #1
Dan Scheurell
Junior Member
 
Join Date: Mar 2007
Location: Middleton, Wisconsin, USA
Posts: 4
Default Time between controller packets

It appears from line 7 of Table 3-2 that the time between any two packets must be 176 us. Does this include the time between two successive start code 0 packets as well?

Thank you,
Dan
Dan Scheurell is offline   Reply With Quote
Old April 1st, 2007   #2
sblair
Administrator
 
Join Date: Feb 2006
Posts: 413
Send a message via AIM to sblair Send a message via MSN to sblair
Default

Dan,

You could probably get away in many cases with a shorter than 176uS BREAK between successive NSC packets.

The reason for the increased BREAK times is to allow in-line devices such as splitters to detect the traffic and turn the line around.

Presumably, if a splitter sees a NSC packet it would not release the lines so it would maintain forward direction. I have seen some splitters that will float the lines during idle time between packets. However, a splitter such as this which had no intelligence would still have to function with non-RDM DMX512 gear as well, so it would need to be capable of driving the line quick enough.

We are trying to get everyone into using 176uS Breaks across the board because it is just a better practice in the RDM world. With RDM packets it is definitely a requirement as it will cause all kinds problems if the BREAK is too short and you'll probably be making the problem appear to be the spllitter when it is actually you.

Between 2 or more successive NSC packets I see it being a minor issue though.

Scott
__________________
Scott M. Blair
RDM Protocol Forums Admin
sblair is offline   Reply With Quote
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
RDM Controller timing clarification Dan Scheurell RDM Timing Discussion 4 May 15th, 2014 10:34 PM
ENTTEC RDM controller (subdevices) nic123 RDM Marketplace Discussion 3 October 24th, 2007 12:03 AM
Exceeding MAB time Dan Scheurell RDM Timing Discussion 2 March 30th, 2007 08:23 AM


All times are GMT -6. The time now is 12:38 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.