E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > Search Forums

Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: eldoMS
Forum: RDM General Implementation Discussion September 1st, 2011
Replies: 2
Views: 4,770
Posted By eldoMS
Detailed questions on STATUS_MESSAGES

Hi

I have a question with regards to properly implementing and interpreting GET STATUS_MESSAGES.

I understand from the RDM2006 errata that there can be two types of RDM protocol support: either...
Forum: RDM Timing Discussion August 23rd, 2011
Replies: 9
Views: 11,881
Posted By eldoMS
Hi Scott/Eric, What is then the exact...

Hi Scott/Eric,

What is then the exact difference between NR_BUFFER_FULL which states buffers or queue full, and NR_PROXY_BUFFER_FULL?

Is the difference only the fact that a responder queue in...
Forum: RDM Interpretation Questions August 21st, 2011
Replies: 4
Views: 4,904
Posted By eldoMS
Hi Eric/Scott, Yes, indeed this can serve...

Hi Eric/Scott,

Yes, indeed this can serve quick turn-arounds, even a little bit more than 1.3 ms, depending on the application the ACK_TIMER reply itself (also 1.3 ms) as well as the max delay to...
Forum: RDM Timing Discussion August 21st, 2011
Replies: 9
Views: 11,881
Posted By eldoMS
Hi Scott/Eric Would this be NR_BUFFER_FULL...

Hi Scott/Eric

Would this be NR_BUFFER_FULL (0x0007), or has a new NR_PROXY_BUFFER_FULL be added after E1.20?

Greetings

Marc
Forum: RDM Timing Discussion August 19th, 2011
Replies: 9
Views: 11,881
Posted By eldoMS
Hi Eric Separate from EE memory writes,...

Hi Eric

Separate from EE memory writes, which I agree can be handled as you describe, there are other reasons a responder needs more time e.g. when it is a proxy or bridge/gateway device to where...
Forum: RDM Interpretation Questions August 19th, 2011
Replies: 4
Views: 4,904
Posted By eldoMS
Interpretation of ACK_TIMER

Hello,

Is it correct that a 0x0000 as an ACK_TIMER response indicates a "come back immediately for the requested and queued data"?

Greetings

Marc
Forum: RDM Timing Discussion August 18th, 2011
Replies: 9
Views: 11,881
Posted By eldoMS
Post Required handling of sequences of RDM broadcast cmds

Hello

When looking at table 3-2 line 6 a controller may continuously send a sequence of broadcast RDM SET commands with minimum spacing of 176 us.

In the broadcast situation the ACK_TIMER...
Forum: RDM General Implementation Discussion August 17th, 2011
Replies: 7
Views: 6,764
Posted By eldoMS
Post Handling incorrect messages

Hello,

I am working on implementing the, hopefully according to the standard, correct actions to be taken on incorrect messages that could be received by a responder.

After reading the standard...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -6. The time now is 07:49 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.