E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > Search Forums

Showing results 1 to 7 of 7
Search took 0.01 seconds.
Search: Posts Made By: sblair
Forum: RDM General Implementation Discussion May 25th, 2010
Replies: 33
Views: 31,412
Posted By sblair
Eric is correct. Most of the SET message...

Eric is correct. Most of the SET message responses do not echo back the value that the field was set to. That only comes back in a GET message response.

While not explicitily stated, Queued...
Forum: RDM General Implementation Discussion May 19th, 2010
Replies: 33
Views: 31,412
Posted By sblair
Yep, a STATUS_MESSAGES response with a PDL of 0...

Yep, a STATUS_MESSAGES response with a PDL of 0 is what you would use, since you have no status messages to respond with...
Forum: RDM General Implementation Discussion May 18th, 2010
Replies: 33
Views: 31,412
Posted By sblair
Yes, it just populates the Sub-Device field of...

Yes, it just populates the Sub-Device field of the response message with the Sub-Device number that the Queued Message is for.
Forum: RDM General Implementation Discussion March 2nd, 2010
Replies: 33
Views: 31,412
Posted By sblair
Bernt, I would send it with the current...

Bernt,

I would send it with the current value. Previous values are much less important.
Forum: RDM General Implementation Discussion March 2nd, 2010
Replies: 33
Views: 31,412
Posted By sblair
I just Queue the PID itself. Then when the...

I just Queue the PID itself. Then when the controller asks I just send whatever the current value is for that PID.

In a limited device, you could use a single BIT to denote the PID. Thus with...
Forum: RDM General Implementation Discussion March 1st, 2010
Replies: 33
Views: 31,412
Posted By sblair
Queued messages are not mandated. Most of us...

Queued messages are not mandated. Most of us wish they were but a few folks were deadset against it.

Ultimately devices that chose not to support Queued Messages may not be as well supported on...
Forum: RDM General Implementation Discussion March 1st, 2010
Replies: 33
Views: 31,412
Posted By sblair
The controller can do whatever it chooses...

The controller can do whatever it chooses ultimately.

If a controller sees that a device does not support Queued messages, then clearly it will have to specifically request parameters that it...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -6. The time now is 11:01 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.