E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > Search Forums

Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: dgaller
Forum: RDM General Implementation Discussion August 20th, 2018
Replies: 1
Views: 741
Posted By dgaller
Possible to use RDM to START a channel at the END of a fixture?

Meaning, if I have 20 fixtures on a building, but the electrician installed one "backwards", is it possible to flip the starting address to the end of the fixture, and the last address to the front...
Forum: RDMnet (BSR E1.33) Draft Standard General Discussion March 5th, 2017
Replies: 18
Views: 13,015
Posted By dgaller
Hello, any update on this? Looking forward to...

Hello, any update on this? Looking forward to implementing this and wondering if the spec was completed? Thanks!
Forum: RDM User Discussion December 13th, 2016
Replies: 4
Views: 2,634
Posted By dgaller
Got it, thanks so much for the info!

Got it, thanks so much for the info!
Forum: RDM User Discussion December 13th, 2016
Replies: 4
Views: 2,634
Posted By dgaller
Aha, so basically the DECODER reports the status...

Aha, so basically the DECODER reports the status of itself back to the ENGINE. BUT, if the decoder sends its PWM signals out the "analog" side (12v/24v), the fixture attached on the analog side...
Forum: RDM User Discussion December 13th, 2016
Replies: 4
Views: 2,634
Posted By dgaller
Fixtures that support RDM?

Hi all, new to RDM and had a few questions:

1. I understand the DMX controller/engine needs to support RDM, but does the fixture?
2. Are there ways of taking a standard fixture and "upgrading"...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT -6. The time now is 08:12 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.